From Dad's email on September 19th:
I am going to Amherst with the loaded trailer of 160-180mm pine posts 3 metre long. Had to go to near Arthur's Seat chairlift to get them. They are excellent and only $10 each. The next size down, 125mm, cost $25 each. These are an exceptional bargain and we ought to buy as many as you envision you will need. He also has 125mm ones both in the 3m and 2.4 m and some 2.4m that are 180-200 that would be excellent for strainer posts. Your call if you want to invest more. He runs an orchard that he is downsizing. He has about 1000 poles that are 9 yrs old but in excellent, and I mean excellent order. Better than new because they have better preservative in them than is presently being used.
Dad ended up getting another load's worth in the end I think, as they're such a good deal and will come in handy for so many projects.
In terms of the wire, Dad said:
I cannot get discounted dog wire so will go with 1.2 m high weldmesh for the bottom that has square gaps of 10cmx10cm. You need 3 rolls at $54 each, plus staples. You have the single strand wire already to make up the top of the fence up to the 2.4, or you can tell me to buy an additional 3 rolls of the weldmesh and make it all weldmesh.
I replied to say to use the same weld mesh wire along the whole fence and also to make sure it was lined up with the wire below if it was going on in two parts.
"What I mean is, make it symmetrical if you can as otherwise I think it might look a little odd to the eye when you're looking up close to see the 'stripes' of the wire that don't match up. If this isn't possible then please leave a gap, say 20-30cm, between the two sheets of wire so they look clearly separate... I'm assuming a small gap like this, 1.2m off the ground, is not going to be possible for any sheep/roo to squeeze through as they're not climbers"
No comments:
Post a Comment